How to Improve the Finish of Honing Pipe

Generally, a Steel Pipe obtained by honing process is called honing pipe. In the honing process of honing pipe, it is common to use honing tools, one of which is honing gear.

Honing gear is composed of the base and abrasive. It is mainly used for honing to remove impurities and burrs on the material surface, so as to improve the surface finish. However, when using this kind of honing tool, we should also pay attention to the following points:

1. The travel of the equipment shall not exceed the width range when honing, otherwise, the honing gear may be seriously damaged.

2. For the control of honing amount, its value should be controlled within a reasonable range. And the control of honing time is also required. It is recommended to be about two minutes.

3. The material of honing gear is brittle, so it is strictly prohibited to knock it to avoid damage and failure to use.

With regard to how to improve the surface finish of honing pipe, it is not difficult to achieve the goal, because we can start from the honing process to achieve it. Further, the above requirements can be met by selecting a suitable honing stone and controlling the roughness to make it within the normal allowable range. However, in some cases, it is necessary to pay attention to the material used for honing pipe and the hardness of the material, so that comprehensive consideration can be taken to avoid problems.